ISO INTERNATIONAL STANDARD 10911 Third edition 2017-06 Solid hardmetal end mills with cylindrical shank Dimensions Fraises cylindriques deux tailles monobloc en metaux-durs- Dimensions Referencenumber IS010911:2017(E) Intemational Organization for Standardization @IS02017 e=ZHEJIANG INST OF STANDARDIZATION C15956617 No reproduction or networking permitted without license from IHS IS0 10911:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS02017,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 copyright@iso.org www.iso.org Intemationaibr PrganizationforStandardization Uicensee-ZHEJIANG INST OF STANDARDIZoISQ 3q,7 -All rights reserved networking permited without license from IHS NotforResale, 2017/9/2705:55:02 IS0 10911:2017(E) Contents Page Foreword ..iv 1 Scope ..1 2 Normative references 3 Terms and definitions ..1 4 Dimensions 5 Centre cutting ..1 AnnexA(informative)Relationshipbetweendesignationsinthisdocumentandthe Is013399series .3 Bibliography .4 Inteainal oganzation @stS.2.0..7 - All rights reserved iii See=ZHEJIANG INSTOFSTANDARDIZATIONC15956617 without license from IHS