ISO INTERNATIONAL STANDARD 11124-5 First edition 2019-06 Preparation of steel substrates before application of paints and related products Specifications for metallic blast-cleaning abrasives - Part 5: Cut steel wire Preparation des subjectiles d'acier avant application de peintures etdeproduitsassimilés- -Spécificationspourpréparationpar projectiond'abrasifs metalliques- Partie 5:Fils d'acier coupés Reference number ISO11124-5:2019(E) @IS0 2019 IS011124-5:2019(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2019 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below orIso's memberbody in the countryof therequester. ISO copyright office CP 401 : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone:+41227490111 Fax:+4122749 09 47 Email: copyright@iso.org Website: www.iso.org Published in Switzerland ii @ IS0 2019- All rights reserved IS0 11124-5:2019(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Termsand definitions 4 Designationofabrasives ..3 5 Sampling 6 Requirementsforcutsteel wireabrasives. ..4 7 Package identification and lot traceability 8 Informationtobeprovidedbythemanufacturerorsupplier. .5 Annex A (informative) Approximately equivalent codings for cut steel wire abrasives. .6 Bibliography .7 @ IS0 2019 -All rights reserved iii