ISO INTERNATIONAL STANDARD 16228 First edition 2017-11 Fasteners Types of inspection documents Fixations - Types de documents de controle Reference number IS0 16228:2017(E) ISO IS02017 IS0 16228:2017(E) COPYRIGHT PROTECTED DOCUMENT @ IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. IsO copyright office Ch. de Blandonnet 8 CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org i @ IS0 2017 - All rights reserved IS0 16228:2017(E) Contents Page Foreword .iv Introduction. .V 1 Scope. 1 2 Normative references. .1 3 Terms and definitions .2 4 Inspection 2 4.1 Types of inspection documents for material 2 4.2 .3 Typesofinspectionforfasteners 4.2.1 Non-specific inspection for fasteners 3 4.2.2 Specific inspection for fasteners 3 4.3 Types of inspection documents for fasteners. 3 4.3.1 General. 3 4.3.2 Fastener declaration of compliance F2.1 3 4.3.3 Fastener test report F2.2. 4 4.3.4 Fastener test report F3.1 4 4.3.5 Fastener test report F3.2. .4 5 Requirements for fastener inspection documents 4 5.1 General .4 5.2 Maintenance of data for inspection documents 5 5.3 Traceability 5 5.4 Inspection document sources. .5 5.5 Subcontracted tests and/or inspection .6 5.6 Sampling. 6 5.7 Reporting of test/inspection results 6 5.8 Minimum results to be included for each type of fasteners 7 5.9 Validation of the inspection document .9 6 Required content for each type of fastener inspection document 9 6.1 General. 9 6.2 Content of the fastener declaration of compliance F2.1 10 6.3 Content of the fastener test report F2.2 10 6.4 Content of the fastener test report F3.1 11 6.5 Content of the fastener test report F3.2 .12 7 Amendment to inspection documents ..13 8 Transmission of inspection documents. ..13 AnnexA(informative)Examplesofinspectiondocuments. ..14 Annex B (informative) Code numbers applicable to fasteners .18 Bibliography .26 @ IS0 2017 - All rights reserved ii