ISO INTERNATIONAL STANDARD 16300-2 First edition 2019-04 Automation systems and integration Interoperability of capability units for manufacturing application solutions - Part 2: Capability templates and software unit cataloguing Systemes d'automatisation et integration - Interopérabilité des unités de capacite pour les solutions d'applications industrielles - Partie 2: Modeles de capacités et cataloguage des unités logicielles Reference number ISO 16300-2:2019(E) ISO @ IS0 2019 IS0 16300-2:2019(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO 2019 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or Iso's member body in the country of the requester. ISO copyright office CP 401 : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +4122 749 0111 Fax: +41 22 749 09 47 Email: [email protected] Website: www.iso.org Published in Switzerland ii @ IS0 2019 - All rights reserved IS0 16300-2:2019(E) Contents Page Foreword ..iv Introduction. 1 Scope. .1 2 Normative references ..1 3 Terms and definitions 4 Overview of software unit catalogue ..3 4.1 Capability profiling defined in the IS0 16100 series .3 4.2 Objectives of the software unit catalogue. .5 5 Software unit catalogue and software capability description dictionary ..7 6 Procedure for software unit cataloguing ..8 6.1 Overall procedure of software unit cataloguing. .8 6.2 Capability profiling using software unit catalogue .9 Annex A (informative) Capability element template ..13 Bibliography ..15 @ IS0 2019 - All rights reserved iii