ISO INTERNATIONAL STANDARD 18885-1 First edition 2017-07 TPMS snap-in valves - Part 1: Identification Valves TPMS snap-in - Partie 1: Identification Reference number ISO 18885-1:2017(E) os1 International Organization for Standardization ZHEJIANG INST OF STANDARDIZATION C1 5956617 @ IS0 2017 Not for Resale, 2017/9/27 05:43:31 No reproduction or networking permitted without license from IHS IS0 18885-1:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinair PrganizationforStandardization icensee-ZHEJIANG INSTOF STANDARDIZAoISQ07-All rights reserVed Not for Resale, 2017/9/27 05:43:31 etworking permitted without license from IHS IS0 18885-1:2017(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Identification .2 4.1 Visible identification from tire external side .2 4.2 .2 Traceability 4.3 Visible identification on the valve .3 Bibliography .4 Intematonal oganzation @stS2017 - All rights reserved iii ISee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under lic ed without license from IHS Not for Resale, 2017/9/27 05:43:31