ISO INTERNATIONAL STANDARD 28219 Second edition 2017-09 Packaging Labelling and direct product marking with linear bar code and two-dimensional symbols Emballage - Etiquetage et marquage direct sur le produit avec un code a barres et des symboles bidimensionnels Reference number IS0 28219:2017(E) ISO ndards and Technology 9972181 @ IS0 2017 rlicense with various National Standards Bodies Not for Resale, 2018/1/22 08:44:0 No reproduction or networking permitted without license from IHS IS0 28219:2017(E) COPYRIGHT PROTECTED DOCUMENT @ IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsoO at the address below or Iso's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org ation for Standardizatior ute of tandards andSog127er All rights reserved Provided by IHS Markit under license with various National Standards Bodies Not for Resale, 2018/1/22 08:44:0 No reproduction or networking permitted without license from IHs IS0 28219:2017(E) Contents Page Foreword iv Introduction V 1 Scope. 2 Normative references .2 3 Terms and definitions .3 4 Requirements 4 4.1 Identification 4 4.1.1 General 4 4.1.2 Unique item identification 5 4.1.3 Lotorbatchidentification 5 4.2 Data format common requirements 5５ 4.2.1 General. 4.2.2 General format 5 4.2.3 Mandatory data fields 6 4.2.4 Optional data fields.. 11 4.2.5 Syntax 13 4.3 General layout and location . 14 4.3.1 Layout 14 4.3.2 Location. .14 4.3.3 Linear bar code titles 14 4.3.4 Human-readable interpretation 14 4.4 Symbol requirements. 15 4.4.1 Symbology recommendations. 15 4.4.2 Linear bar code symbol requirements 15 4.4.3 Two-dimensional symbol requirements 17 4.4.4 Composite symbol requirements 23 4.5 Adhesive requirements .25 Annex A (informative) Label adhesive characteristics and mark durability .26 Annex B (informative) Partial list of commonly used identifiers .34 Annex C (informative) Subset of ISO/IEC 646 (table of hexadecimal and decimal values) .36 Annex D (informative) User guidance for implementation of the IS0/IEC 15434 data syntax .38 Annex E (informative) For applications using Code 39 and Code 128 symbologies .39 Annex F (informative) Using DUNS?, with ASC MH10 Data Identifiers (DIs) in linear bar codeandtwo-dimensionalsymbols. .43 Annex G (informative) Register of issuing agency codes (IACs) for IS0/IEC 15459 ..45 Annex H (informative) Serialization of some electronics products .46 Annex I (informative) MoD 36 interior service number "check character" caicuiation .52 Bibliography .54 ation @stsr207 - All rights reserved ii qy9972181 Not for Resale, 2018/1/22 08:44:0 No reproduction or networking permited without license from IHs