ISO INTERNATIONAL STANDARD 10129 Second edition 2017-03 Plain bearings - Testing of bearing metals Resistance to corrosion by lubricants under static conditions Paliers lisses - Essai des materiaux antifriction Resistance a la corrosion par des lubrifiants dans des conditions statiques Reference number IS0 10129:2017(E) International Organization for Standardization @ IS0 2017 ee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 mitted without license from IHS IS0 10129:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 · CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Internationai ibrg DrganizationforStandardization Licensee-ZHEJIANG INST OF STANDARDIZRoSQ 7 - All rights reserved Not for Resale, 2017/6/28 01:01:15 networking permited withoutlicense from IHS IS0 10129:2017(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms and definitions 4 Health and safety. ..1 5 General principles ..1 6 Lubricants ..2 7 Apparatus ..2 8 Preparation of test samples ..2 9 Test procedure. ..3 10 Expression of results .3 10.1 Mass change. 10.2 Changes in dimensions .3 10.3 Surface changes .3 10.4 Microstructural changes. .4 10.5 Type and nature of the corrosion products 10.6 Change of lubricant. .4 11 Test report .4 Bibliography 5 ii icensee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under I se with ISt Not for Resale, 2017/6/28 01:01:15 ed without license from IHS