ISO INTERNATIONAL STANDARD 10360-8 Firstedition 2013-12-01 Geometrical product specifications (GPS) Acceptance and reverification tests for coordinate measuring systems (CMS) - Part 8: CMMs with optical distance sensors Spécification géométrique des produits (GPS)-Essais de réception etdevérificationperiodique des systemesdemesure tridimensionnels (SMT)- Partie8:MMTavec détecteurs optiques sans contact Referencenumber IS010360-8:2013(E) LSO Copyright International Organization for Standardization @IS02013 cense from IHS Not for Resale IS010360-8:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. + 4122 749 0111 Fax +41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2013- All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS0 10360-8:2013(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normative references 3 Terms and definitions ..2 4 Symbols ..9 5 Requirements for metrological characteristics .10 5.1 Environmental conditions .10 5.2 Operating conditions .10 5.3 Probing form error. .11 5.4 Probing dispersion value .11 5.5 Probing size error. .11 5.6 Probing size error All 11 5.7 Length measurement error .12 5.8 Flatformmeasurementerror .12 5.9 Workpiece loading effects .12 6 Acceptancetests and reverification tests .13 6.1 General .13 6.2 Probing characteristics .13 6.3 Lengthmeasurementerror 20 6.4 Flatformmeasurementerror 23 7 Compliancewith specifications .26 7.1 Acceptancetest 26 7.2 Reverification test 27 8 Applications 28 8.1 Acceptance test 28 8.2 Reverificationtest 28 8.3 Interimcheck ..28 6 Indicationinproductdocumentationanddatasheets .28 AnnexA (informative)Structuralresolutiontest .29 AnnexB (normative) Artefacts that representa calibrated test length .34 AnnexC (informative) Alignment ofartefacts .44 Annex D (normative) Articulated location value of CMMs with articulating probing system for optical distance sensors. .46 AnnexE (informative)RelationtotheGPSmatrixmodel .49 Bibliography .51 iii Sta thout license from IHS Not for Resale