ISO INTERNATIONAL STANDARD 10889-6 Third edition 2016-03-15 Tool holders with cylindrical shank Part 6: Type E with cylindrical seat Porte-outil a queue cylindrique - Partie 6: Porte-outil de type E pour outils a queue cylindrique Reference number IS0 10889-6:2016(E) ISO @ IS0 2016 HS under 5001, User=peng, Lu ted without license from IHS 59:19 MD IS0 10889-6:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org @ IS0 2016 - All rights reserved Noreproduc networking permitted without license from IHS NotforResale, 03/18/201608:59:19MD IS0 10889-6:2016(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references ..1 3 Dimensions. 3.1 General .1 3.2 Tool holder of type E1 3.3 Tool holder of type E2. .3 3.4 Tool holder of type E3 3.5 Tool holder of type E4 .6 4 Designation 1 5 Technical delivery conditions ..8 5.1 General. .8 5.2 Design 5.3 Scope of delivery ..8 Annex A (informative) Relationship between designations in this part of Is0 10889 and IS013399 .9 Bibliography ..10 Copyriotiteatioal ohzl/S0t:2 ahraz-ll ights reserved iii d by IHS under thout license from IHS 001, User=peng, Lu