ISO INTERNATIONAL STANDARD 10896-4 Firstedition 2015-11-01 Rough-terrain trucks Safety requirements and verification Part 4: Additional requirements for variable-reach trucks handling freely suspended loads Chariots tout-terrain - Exigences de sécurité et vérification - Partie 4: Exigences additionnelles pour chariots a portee variable manipulant des charges suspendues a oscillation libre Reference number ISO 10896-4:2015(E) SO International Organization for Standardization @ IS0 2015 STANDARDIZATION C15956617 ed without license from IHS IS0 10896-4:2015(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Intenatinair Prganization for Standardization ensee-ZHEJIANG INST OF STANDARDIzARoISQ15- All rights reserved networking permitted without license from IHS IS0 10896-4:2015(E) Contents Page Foreword ..iv Introduction. 1 Scope. 2 Normative references 3 Terms and definitions .2 4 Safety requirements and/or protective measures .3 4.1 General requirements .3 4.2 Mounting and fixing. .3 4.3 Design and strength. 4 4.3.1 Lifting attachment ..4 4.3.2 Wire rope hoist attachments. 4 4.4 Stability. ..5 4.4.1 Load chart for suspended load lifting attachment(s) .5 5 Verification of the safety requirements and/or protective measures .5 5.1 General .5 5.2 Tests for trucks fitted with lifting attachments. .5 5.3 Static strength test 5 5.3.1 General 5 5.3.2 Test procedure 5 5.3.3 Verification. 5 5.4 Dynamic structural tests 5 5.4.1 General .5 5.4.2 General test set up 5 5.4.3 Test procedure. ..6 5.4.4 Verification. .6 5.5 Additional requirements for pick and carry .7 5.5.1 General. .7 5.5.2 Stability by test loading ..7 5.5.3 Requirements 1 6 Information for use .7 6.1 Content requirements .7 Bibliography 9 iii ee=ZHEJIANG INST OF STANDARDIZATION C15956617 vided by IHS under ithout license from IHS Not for Resale, 2016/1/8 01:59:47