ISO INTERNATIONAL STANDARD 11748-2 Firstedition 2001-06-01 Road vehicles - Technical documentation of electrical and electronic systems - Part 2: Documentation agreement Véhicules routiers -- Documentation technique des systemes électriques et électroniques Partie 2:Accorddocumentaire Referencenumber ISO 11748-2:2001(E) ISO @ISO2001 Copyright by the International Organization For Standardization ISO 11748-2:2001(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, AdobeisatrademarkofAdobeSystemsIncorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the fite; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. 1 iSO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utlized in any form or by any means, elec- berbody inthe countryofthe requester. Iso copyright office Case postale56·CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii @ IsO 2001 - All rights reserved ISO 11748-2:2001(E) Foreword the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with Iso, also take part in the work. so collaborates closely with the International 'Eiectrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISOAEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of Iso 11748 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 11748-2 was prepared by Technical Committee ISO/TC 22, Road vehicles Subcommittee sc 3, Electrical and electronic equipment. iso 11748 consists of the following parts, under the general title Road vehicles - Technical documentation of electricalandelectronicsystems Part 1: Content of exchanged documents Part2:Documentation.agreement Part 3: Application example @IsO2001-All rightsreserved li