ISO INTERNATIONAL STANDARD 12132 Second edition 2017-03 Plain bearings Quality assurance of thin-walled half bearings Design FMEA Paliers lisses - Assurance qualité des demi-coussinets minces - AMDE a la conception Reference number ISO 12132:2017(E) International Organization for Standardization @ IS0 2017 =ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under lic Not for Resale, 2017/5/16 00:33:39 itted without license from IHS IS0 12132:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinair PrganizationforStandardization icensee-ZHEJIANG INSTOF STANDARDizOISQO7-All rights reserVed Not for Resale, 2017/5/16 00:33:39 etworking permitted without license from IHS IS0 12132:2017(E) Contents Page Foreword ..iv Introduction. 1 Scope.. 2 Normative references 3 Terms and definitions 4 Common potential failure modes, effects and causes for half bearing shells Bibliography Inteatinal oganzation @st(Sar2.a..7 - All rights reserved iii ee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS underI ed without license from IHS Not for Resale, 2017/5/16 00:33:39