ISO INTERNATIONAL STANDARD 1268-5 First edition 2001-06-01 Fibre-reinforced plastics Methods of producing test plates - Part 5: Filament winding Plastiques renforcés de fibres - Méthodes de fabrication de plaques d'essai- Partie 5: Moulage par enroulement filamentaire Reference number ISO 1268-5:2001(E) Tso @ ISO 2001 Copyright inteinatioal Organizatin for Standardizatin No reproduction or networking permitted without license from IHS Not for Resale ISO 1268-5:2001(E) PDF disclaimer This PiDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited:unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, elec- tronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's mem- ber body in the country of the requester. ISO copyright office Casepostale 56·CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland CyationalganzainStandardizatio @ ISO 2001 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 1268-5:2001(E) Contents Page Scope 2 Normative reference 3 Health and safety 4 Principle 5 Materials 2 6 Plate dimensions 2 7 Reinforcement content 2 8 Apparatus 2 9 Procedure. 9 10Verification of the characteristics of the plates obtained 7 11 Test plate preparation report 8 Annexes A Examples of winding parameters.... 9 B Calculation of winding parameters for preparing unidirectional plates by winding.. 10 Copyright InternationalOrganizationforStandardizationserved ili No reproduction or networking permitted without license from IHS Not for Resale