ISO INTERNATIONAL STANDARD 13007-2 Third edition 2013-11-01 Ceramic tiles Grouts and adhesives Part 2: Test methods for adhesives Carreaux céramiques Mortiers de joints et colles - Partie 2: Méthodes d'essai pour les colles Reference number IS0 13007-2:2013(E) LSO IS02013 HS under ted without license from IHS Not for Resale IS0 13007-2:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 13007-2:2013(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references ...1 3 General test conditions and procedures 3.1 Sampling .1 3.2 Test conditions. 3.3 Test materials. 2 3.4 Mixing procedures 2 3.5 Test substrate. 3 3.6 Failure patterns .3 3.7 Test report. .3 4 Test methods. .4 4.1 Determination of open time .4 4.2 Determination of slip .5 4.3 Determination of shear adhesion strength (D, R) .7 4.4 Determination of tensile adhesion strength (C) 4.5 Determination of transverse deformation. ..11 Annex A (informative) Concrete test slab .23 iii ded by IHS under license with ISC ed without license from IHS Not for Resale