ISO INTERNATIONAL STANDARD 13085 First edition 2014-03-15 Petroleum and natural gas industries Aluminium alloy pipe for use as tubing for wells Industries du pétrole et du gaz naturel - Tubes en alliage d'aluminium utilisés comme tubes de production dans les puits Reference number ISO 13085:2014(E) ISO Copyriaht intemational Organizatin for Standardizatin @IS02014 Not for Resale IS0 13085:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS0 13085:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms, definitions and symbols ..1 3.1 Terms and definitions .1 3.2 Symbols.... 4 Information to be supplied by purchaser .3 5 Process of manufacture and delivery condition .3 5.1 General .3 5.2 Heat treatment .3 5.3 Traceability .3 5.4 Delivery condition .4 6 Material requirements ..4 6.1 Material groups. .4 6.2 Metallographic examination. .4 6.3 Chemical composition .5 6.4 Tensile properties. .5 Configuration and dimensions of pipes ..5 7.1 Configuration .5 7.2 Length. .5 7.3 Dimensions of pipes ..5 7.4 Design mass .6 7.5 Upset run-out. .6 7.6 Straightness ..6 7.7 Ovality and eccentricity of pipes 7.8 Drift requirements. .6 7.9 Internal coating .6 8 Test methods. .6 9 Measuring methods ..8 10 Inspection .9 11 Marking. ..9 12 Packaging, transport and storage ..9 13 ..9 13.1 Certification ..9 13.2 Retention of records ..10 14 Delivery conditions ..10 15 Minimum facility requirements for pipe mill ..10 Annex A (normative) Purchaser inspection ..11 Annex B (normative) Corrosion test ..12 Bibliography ..13 ii ise with IS ed without license from IHS Not for Resale