ISO INTERNATIONAL STANDARD 13106 First edition 2014-05-15 Plastics Blow-moulded polypropylene containers for packaging of liquid foodstuffs Plastiques - Récipients en polypropylene moules par soufflage pour I'emballage de denrées alimentaires liquides Reference number IS0 13106:2014(E) ISO International Organization for Standardization e=Zhejiang Institute of Standardization 5956617 @IS02014 vided by IHS under I No reproduction or networking permitted without license from IHS IS0 13106:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland Internatinai br DrganizationforStandardization HS und Not for Resale, 2015/3/11 02:18:07 networking permited without license from IHS IS0 13106:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references ..1 3 Terms and definitions 4 Raw material. 5 Container capacity ..4 6 Container mass. .4 7 Tolerance on dimensions. ..4 7.1 General 7.2 Wall thickness .4 7.3 Overall height (OH) .4 7.4 Diameter (D) ..4 7.5 Neck height (H) 4 7.6 .5 External neck diameter (E) 7.7 Internal neck diameter () 5 7.8 Thread diameter (T) .5 7.9 Neck ovality .5 8 Performance requirements .5 8.1 General .5 8.2 Closure leakage test .5 8.3 Drop impact resistance test. .5 8.4 Stack load test. .5 8.5 Leakage test .5 8.6 Ink adhesion test. .6 8.7 Compatibility test ..6 9 Statutory marking .6 10 Sampling and criterion for conformity .6 10.1 Sampling criterion .6 10.2 Number of tests and criteria for conformity .6 Annex A (normative) Container and neck finish descriptions ..8 Annex B (normative) Determination of brimful capacity ..9 Annex C (normative) Measurement of container wall thickness .10 Annex D (normative) Measurement of container overall height ..11 Annex E (normative) Measurement of diameter for round container. ..12 Annex F (normative) Measurement of neck height. ...13. Annex G (normative) Measurement of neck and thread diameters and neck ovality Annex H (normative) Drop impact resistance test ..15 Annex I (normative) Stack load test ..16 Annex J (normative) Leakage test ..17 Annex K (normative) Ink adhesion test for printed containers. ..18 iii ed without license from IHS