ISO INTERNATIONAL STANDARD 13845 Secondedition 2015-02-15 Plastics piping systems Elastomeric-sealing-ring-type socket joints for use with thermoplastic pressure pipes Test method for leaktightness under internal pressure and with angular deflection Systemes de canalisations en plastiques - Assemblages par emboiture a bague d'étancheité en élastomere pour les tubes sous pression plastiques - Méthode d'essai d'étanchéité sous pression interne et avec déviation angulaire Reference number IS0 13845:2015(E) SO International Organization for Standardization @ IS0 2015 dardization5956617 d without license from IHS IS0 13845:2015(E) COPYRIGHTPROTECTEDDOCUMENT ISO2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland Prganizationfor Standardization networking permtted without license from IHS IS0 13845:2015(E) Contents Page Foreword ..iv 1 Scope. .1 2 Principle 3 Test parameters and requirements 4 Apparatus. 5 Test pieces preparation 6 Procedure. ..2 7 Test report ..3 Annex A (normative) Test parameters .5 Inteatinal oganzation @stS201.5 - All rights reserved iii see=Zhejiang Institute of Standardization 5956617 vided by IHS under se with ISt ed without license from IHS Not for Resale, 2015/6/2 06:33:14