ISO INTERNATIONAL STANDARD 14085-6 Firstedition 2015-03-01 Aerospace series Hydraulic filter elements Test methods Part 6: Initial cleanliness level Sérieaerospatiale-Elementsfiltrantshydrauliques-Méthode d'essais- Partie 6: Niveau de proprete Reference number IS014085-6:2015(E) ISO Intemational Organization for Standardization @IS02015 Standardization5956617 ed without license from IHS IS014085-6:2015(E) COPYRIGHTPROTECTEDDOCUMENT @IS0 2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax +41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland PrganizationforStandardization No reproduction or networking permitted without license from IHS Not for Resale, 2015/6/2 06:50:48 IS0 14085-6:2015(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normative references 3 Terms and definitions 4 Summary of test method ..1 5 Materials and equipment ..1 6 Procedure ..2 7 Contaminant analysis .3 7.1 Method of analysis 7.2 Reporting of results .3 8 Criterion foracceptance .3 9 Identification statement. ..3 AnnexA (informative)Contaminantanalysismethods .4 Annex B (informative)Filterelementcleanliness test data reportform .6 Bibliography 7 Inteainal oganzation @stS.20.1.5 - All rights reserved iii thout license from IHS