ISO INTERNATIONAL STANDARD 14122-2 Second edition 2016-06-01 Safety of machinery Permanent means of access to machinery - Part 2: Working platforms and walkways Sécurité des machines - Moyens d'acces permanents aux machines- Partie 2: Plates-formes de travail et passerelles Reference number IS0 14122-2:2016(E) ISO International Organization for Standardization @ IS0 2016 ZHEJIANG INST OF STANDARDIZATION C1 5956617 ted without license from IHS IS0 14122-2:2016(E) COPYRIGHT PROTECTED DOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 · CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinir DrganizationforStandardization icensee-ZHEJIANG INSTOF STANDARDIZAoISQ 06 - All rights reserved Not for Resale, 2016/7/20 07:47:36 networking permited withoutlicense from IHS IS0 14122-2:2016(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms and definitions .2 4 General requirements. .3 4.1 General 3 4.1.1 Construction and materials .3 4.1.2 Safe access of operators. 3 4.2 Specific requirements .3 4.2.1 Location 3 4.2.2 Dimensions .3 4.2.3 Facilities or equipment. .6 4.2.4 Floorings. .6 4.2.5 Design and construction for working platforms and walkways .8 4.2.6 Manoeuvrable platforms and walkways. .9 5 Information for use for working platforms and walkways .9 Annex A (informative) Different methods of determining levels of slip-resistance ..10 Annex B (informative) Significant technical changes between this part of Is0 14122 and the previous edition. .11 Bibliography .13 iii nSee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 thout license from IHS