ISO INTERNATIONAL STANDARD 14323 Secondedition 2015-03-01 Resistance welding Destructive testing of welds - Specimen dimensions and procedure for impact tensile shear test and cross- tension testing of resistance spot and embossed projection welds Soudageparrésistance-Essaisdestructifsdessoudures- Dimensionsdeséprouvettesetmodeopératoirepourlesessaisde cisaillementpar chocet lesessaisdetractionparchocsuréprouvettes Reference number ISO14323:2015(E) LSO Intermational Organization for Standardization @IS02015 Instituteof Standardization5956617 Not for Resale, 2015/6/2 06:43:20 nout license from IHS IS014323:2015(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO 2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. +4122 749 0111 Fax +41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland PrganizationforStandardization networking permited without license from IHS NotforResale, 2015/6/206:43:20 IS014323:2015(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normative references 3 Termsanddefinitions 4 Test specimen ..1 5 Testequipmentandtestingprocedure .2 5.1 General. .2 5.2 Modified pendulummachine. 5.3 Drop-weight machine. .5 6 Test records. .10 7 Test report ..10 Annex A (informative) Determination offailure energy ..12 Bibliography. .15 Inteatinal oganzation @stS.20.1.5 - All rights reserved iii ithout license from IHS