ISO INTERNATIONAL STANDARD 14343 Third edition 2017-03 Welding consumables - Wire electrodes, strip electrodes, wires and rods for arc welding of stainless and heat resisting steels Classification ProduitsconsommablespourlesoudageFils-électrodes,électrodes en feuillard,fils d'apport et baguettes de soudage pour le soudage a I'arc des aciers inoxydables et des aciers resistant auxtempératures élevées-Classification Referencenumber IS014343:2017(E) iso Intemational Organization for Standardization @IS02017 ed without license from IHS IS014343:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS02017,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 copyright@iso.org www.iso.org Intematinaibr PrganizationforStandardization Uicensee-ZHEJIANG INST OF STANDARDIZoISQ 3q,7 -All rights reserved networking permited without license from IHS Notfor Resale, 2017/5/16 00:45:21 IS014343:2017(E) Contents Page Foreword ..iv Introduction.. 1 Scope. 2 Normative references 3 Termsand definitions ..1 4 Classification .2 4.1 General .2 4.2 Symbolsforproducts/processes .2 4.3 Symbols for chemical composition .2 5 Properties ofall-weld metal .12 6 Chemical analysis .12 7 Rounding procedure. ..12 8 Retesting ..12 9 Technical delivery conditions ..12 10 Examplesofdesignation. ..12 Annex A (informative) Expected minimum tensile properties of all-weld metal ..14 Bibliography ..17 iii 2e=ZHEJIANG INSTOFSTANDARDIZATIONC15956617 ithout license from IHS