FINAL INTERNATIONAL ISO/FDIS DRAFT STANDARD 14554-2 ISO/TC 44/SC 6 Quality requirements for welding Secretariat: DIN Resistance welding of metallic Voting begins on: 2013-07-18 materials Voting terminates on: Part 2: 2013-09-18 Elementary quality requirements Exigences de qualité en soudage - Soudage par reésistance des matériaux métalliques Partie 2: Exigences de qualité élémentaire Please see the administrative notes on page ii SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION Reference number BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO- ISO/FDIS 14554-2:2013(E) LOGICAL,COMMERCIALANDUSERPURPOSES DRAFT INTERNATIONAL STANDARDS MAY ON SO OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OFTHEIR POTENTIALTO BECOME STAN DARDS TO WHICH REFERENCE MAY BE MADE IN @IS02013 IHS unde nse from IHS Not for Resale IS0/FDIS 14554-2:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +4122 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permitted without license from IHS Not for Resale IS0/FDIS 14554-2:2013(E) ISO/CEN PARALLEL PROCESSING This final draft has been developed within the International Organization for Standardization (Iso), and pro- cessed under the Iso-lead mode of collaboration as defined in the Vienna Agreement. The final draft was established on the basis of comments received during a parallel enquiry on the draft. This final draft is hereby submitted to the ISO member bodies and to the CEN member bodies for a parallel two-month approval vote in ISO and formal vote in CEN. Positive votes shall not be accompanied by comments. Negative votes shall be accompanied by the relevant technical reasons. iii Not for Resale