ISO INTERNATIONAL STANDARD 14622 First edition 2000-12-15 Space systems Structural design Loads and induced environment Systemes spatiaux - - Conception des structures Charges et environnementinduit Reference number ISO 14622:2000(E) [So @ ISO 2000 E"eqr[tkijvgf'd{"WPG."E1"1gpqxc."8l"4 :226"Ocftkf."Urckp"cn'tkijv "tgugtxgf+"Ygf°Hgd'36*27<36<76WVE*4246 ISO 14622:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing.In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel.+ 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii so2000-All rightsreserved E*eqr[tkijvgf"d["WPG.'E1"1gpqxc."8I"4:226"Ocftkf.'Urckp"cm'tkijv'tgugtxgf+*Ygf"Hgd’36*27<3676"WVE*4246 knni"cwintiInf ISO 14622:2000(E) Contents Page Foreword. .iv 1 Scope .. 2 Terms and definitions .. 3 Determination of loads and the induced environment . 3.1 General input data ........ 5 3.2 Determination of loading conditions.. 3.3 Safety factors ... 3.4 Cases of design load.. 9 3.5 Calculated safety margins ili nu'rwvintk1nfl