ISO INTERNATIONAL STANDARD 14801 Third edition 2016-11-01 Dentistry Implants Dynamic loading test for endosseous dental implants Medecine bucco-dentaireImplants-Essaide charge dynamique pour implants dentaires endo-osseux Reference number ISO 14801:2016(E) ISO Intemational Organization for Standardization @IS02016 ted without license from IHS IS0 14801:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS02016,Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISo copyright office Ch.de Blandonnet 8.CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 copyright@iso.org www.iso.org etworking permitted without license from IHS IS0 14801:2016(E) Contents Page Foreword ..iv 1 Scope. 2 Normativereferences 3 Terms and definitions 4 General principles. .2 4.1 Finished device testing .2 4.2 Multi-partendosseous dental implants .2 4.3 Worst-case testing. .2 5 Test methods. .3 5.1 Testing machine .3 5.2 Loading geometry 3 5.3 Specimen holder and load application .6 5.4 Testing environment .7 5.5 Loading frequency and wave form .1 5.6 Procedure. .7 5.7 Alternativeprocedure-Staircasemethod .8 6 Reporting .9 Annex A (informative) Load-cycle diagram .11 AnnexB (informative)Guideto determinationof worst-caseconditions .12 Bibliography .16 iii thout license from IHS