ISO INTERNATIONAL STANDARD 16841 First edition 2014-03-01 Steel wire ropes Pulling eyes for rope installation - Types and minimum reguirements Cables en acier - Oeils de tirage pour les installations en cable Types et exigences minimales Reference number IS0 16841:2014(E) LSO IS02014 HS under No repr ted without license from IHS Not for Resale IS0 16841:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 16841:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms and definitions 4 Requirements .2 4.1 General .2 4.2 Geometry. .3 4.3 Type testing .6 4.4 Puiling eye working load limit (WLL) 1 4.5 Welder qualification for rigid-type pulling eyes 7 5 Verification of the requirements 1 5.1 Tensiletest .7 5.2 Durability test ..8 Information for use .8 6 6.1 Marking. ..8 6.2 Certificateofcompliance 8 Annex A (informative) Determination of the line pull to which the pulling eye is subjected during installation or a re-reeving operation 9 Bibliography 10 iii ded by IHS under lic ense with ISt thout license from IHS Not for Resale