ISO INTERNATIONAL STANDARD 17096 First edition 2015-08-01 Cranes Safety Load lifting attachments Appareils de levage a charge suspendue-SécuritéAccessoires de prehension Reference number ISO 17096:2015(E) ISO @IS02015 IS0 17096:2015(E) COPYRIGHT PROTECTED DOCUMENT @ IS0 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or Iso's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 copyright@iso.org www.iso.org @ IS0 2015 - All rights reserved IS0 17096:2015(E) Contents Page Foreword .iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions .2 4 Safety requirements and/or measures. .7 4.1 General requirements .7 4.1.1 Mechanical load bearing parts. .7 4.1.2 Controls. ..7 4.1.3 Handles .7 4.1.4 Requirements for slings which are integrated 4.1.5 Stability during storage .8 4.2 Specific requirements for each category of attachment. .8 4.2.1 Plate clamps ..8 4.2.2 Vacuum lifters. ..8 4.2.3 Lifting magnets. .10 4.2.4 C-hooks. .11 4.2.5 Liftingforks 11 4.2.6 Lifting beams .12 4.2.7 Clamps ..13 5 Verification of the safety requirements and/or measures ..14 5.1 General .14 5.2 Proof of fatigue strength by testing ..18 5.3 Minimum classification. .19 6 Information for use .19 6.1 Instruction handbook 19 6.1.1 General information .19 6.1.2 Specificinformation 19 6.1.3 Guidance formaintenance 22 6.1.4 Verifications and inspections .23 6.2 Marking 23 6.2.1 General. .23 6.2.2 Minimum marking. 23 6.2.3 Additional marking. .23 Annex A (normative) General verification methods .25 Annex B (normative) Verification methods for plate clamps .27 Annex C (normative) Verification methods for vacuum filters .31 Annex D (normative) Verification methods for lifting magnets .37 Annex E (normative) Verification methods for lifting beams. ..42 Annex F (normative) Verification methods for lifting forks ..44 Annex G (normative) Verification methods for clamps ..45 sno Sandardizann rights reserved iii