ISO INTERNATIONAL STANDARD 17296-2 Firstedition 2015-01-15 Additive manufacturing General principles - Part 2: Overview of process categories and feedstock Fabricationadditive-Principesgeneraux Partie 2: Vue d'ensemble des categories de procedés et des matieres premieres Reference number ISO17296-2:2015(E) LSO Intermational Organization for Standardization @IS02015 rdization5956617 ed without license from IHS IS017296-2:2015(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. +4122 749 0111 Fax +41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland PrganizationforStandardization networking permited without license from IHS NotforResale, 2015/3/1101:34:4 IS0 17296-2:2015(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normative references 3 Terms and definitions 4 Part types and their classification 4.1 General .1 4.2 Classificationof parts .1 5 Process chains .2 6 Process categories 2 6.1 General 2 6.2 Existing process categories .3 6.2.1 Vat photopolymerization .3 6.2.2 Material jetting .3 6.2.3 Binderjetting 4 6.2.4 Powder bed fusion .5 6.2.5 Material extrusion 6 6.2.6 Directed energy deposition .6 6.2.7 Sheet lamination .8 ntemational oganzation@S25-All rights reserved iii ithout license from IHS