ISO INTERNATIONAL STANDARD 17357-1 First edition 2014-01-15 Ships and marine technology Floating pneumatic rubber fenders - Part 1: High pressure Navires et technologie maritime Eperons pneumatiques flottants - Partie 1: Haute pression Reference number ISO 17357-1:2014(E) LSO @ IS0 2014 I without license from IHS Not for Resale IS0 17357-1:2014(E) COPYRIGHTPROTECTEDDOCUMENT ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 17357-1:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. .1 2 Normative references ..1. 3 Terms and definitions ..1 4 Classification .3 4.1 High-pressure fender types .3 4.2 Initial internal pressure .3 5 Ordering or inquiring information .3 5.1 Information to the manufacturer .3 5.2 Information from the manufacturer .3 Requirements 6 6.1 General high pressure fender requirements 4 6.2 Type requirements ..4 6.3 Pressure requirements 4 7 Performance. .5 .5 7.1 Specification of performance. 7.2 Performance curves. .5 7.3 Fender performance. .5 8 Performance confirmation of prototype fender test .5 8.1 General. .5 8.2 Performancetest,parallel compression test. .6 8.3 Angular compression test. .8 8.4 Durability test. .8 8.5 Compression-recovery test .8 8.6 Puncture-resistance test .8 8.7 Recording condition. .9 9 Test and inspection for commercial fenders. .9 9.1 General .9 9.2 Material test of rubber .9 9.3 Dimensional inspection. .9 9.4 Air-leakage test. ..9 9.5 Hydrostatic-pressure test .9 10 Marking ..10 11 Documentation. ..10 12 Inspection and evaluation by a qualified independent inspection service ..11 Annex A (informative) Synthetic-tyre-cord layer ..15 Annex B (informative) Flange opening and bead ring, metal parts ..17 Bibliography. .20 iii ense with ISt ed without license from IHS Not for Resale