ISO INTERNATIONAL STANDARD 17916 First edition 2016-03-15 Safety of thermal cutting machines Sécurité des machines de coupage thermique Reference number ISO 17916:2016(E) ISO International Organization for Standardization =ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02016 vided by IHS under IS0 17916:2016(E) COPYRIGHTPROTECTEDDOCUMENT ISO 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinair PrganizationforStandardization ensee-ZHEJIANG INST.OF STANDARDIzARoISQ16- All rights reserved Not for Resale, 2016/4/26 03:37:58 etworking permitted without license from IHS IS0 17916:2016(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. .1 2 Normative references ..1 3 Terms and definitions ..2 4 Significant hazards ..4 5 Safety requirements and protective measures ..4 5.1 General .4 5.2 List of safetyrequirements .5 6 Information for use .15 6.1 General. 15 6.2 Instruction handbook .15 6.3 Noise declaration .16 6.4 Marking 16 Annex A (informative) Examples of hazards, hazardous situations, and hazardous events ..17 Annex B (informative) Calculation examples for dimensioning of exhaust systems ..21 Annex C (informative) Example for the lower limit of protective devices .24 Annex D (informative) Example for calculation of the compression corresponding to the acceptable maximum force in case of collision between the machine and a human body..25 Annex E (normative) Measurement of the air velocity at the entrance plane of the cutting table...27 Bibliography .28 iii HEJIANG INST OF STANDARDIZATION C15956617 ut license from IHS