ISO INTERNATIONAL STANDARD 18185-3 Secondedition 2015-12-01 Freight containers Electronic seals - Part 3: Environmental characteristics Récipients de fret -Joints électroniques - Partie 3: Caractéristiques environnementales Reference number ISO 18185-3:2015(E) SO International Organization for Standardization @ IS0 2015 ZHEJIANG INST OF STANDARDIZATION C15956617 vided by IHS under itted without license from IHS IS0 18185-3:2015(E) COPYRIGHTPROTECTEDDOCUMENT IS02015,PublishedinSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel.+41 22 749 01 11 Fax+412274909 47 copyright@iso.org www.iso.org Intenationai br Prganization for Standardization icensee-ZHEJIANG INST.OF STANDARDIzAoISQ s.5 -All rights reserved vided by IHS unde etworking permitted without license from IHS IS0 18185-3:2015(E) Contents Page Foreword ..V Introduction. ...vi 1 Scope. 2 Normative references 3 Terms and definitions 1 4 Environmental characteristics 2 4.1 General .2 4.2 Lowtemperature .2 4.2.1 Test purpose. 2 4.2.2 Test requirement .2 4.2.3 Test method for storage temperature testing 2 4.2.4 Test method for operating temperature testing .3 4.3 High temperature.. 3 4.3.1 Test purpose .3 4.3.2 Test requirement 3 4.3.3 Test method for storage temperature testing 3 4.3.4 Test method for operating temperature testing .3 4.4 Mechanical shock. 4 4.4.1 Test purpose .4 4.4.2 Test requirement 4 4.4.3 Test method. .4 4.5 Vibration 5 4.5.1 Testpurpose .5 4.5.2 Test requirement .5 4.5.3 Test method. .5 4.6 Humidity. .6 4.6.1 Test purpose .6 4.6.2 Test requirement 4.6.3 Test method. .6 4.7 Rain and snow. 4.7.1 Test purpose 7 4.7.2 Test requirement 7 4.7.3 Test method. 7 4.8 Salt fog .8 4.8.1 Test purpose .8 4.8.2 Test requirement 8 4.8.3 Test method. ..8 4.9 Drop shock. ..8 4.9.1 Test purpose 4.9.2 Test requirement .8 4.9.3 Test method. 4.10 Sand and dust. .9 4.10.1 Test purpose .9 4.10.2 Test requirement .9 4.10.3 Test method. .9 4.11 Electromagnetic environment .9 4.11.1 Test purpose .9 4.11.2 Test requirement .10 4.11.3 Test method. .10 4.12 Solar radiation. 10 4.12.1 Test purpose .10 4.12.2 Test requirement ..10 4.12.3 Test method. ..10 iii ISee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 ed without license from IHS