ISO INTERNATIONAL STANDARD 18243 First edition 2017-04 Electrically propelled mopeds and motorcycles Test specifications and safety requirements for lithium-ion battery systems Cyclomoteurs et motocyclesapropulsion électrique-Spécifications d'essai et exigences de sécurite pour les systemes de batterie au lithium-ion Reference number IS0 18243:2017(E) rso International Organization for Standardization ZHEJIANG INST OF STANDARDIZATION C15956617 @IS0 2017 ed without license from IHS IS0 18243:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinair PrganizationforStandardization icensee-ZHEJIANG INSTOF STANDARDIZAoISQ07 -All rights reserved Not for Resale, 2017/8/21 01:30:55 etworking permitted without license from IHS IS0 18243:2017(E) Contents Page Foreword ..V Introduction. ...vi 1 Scope 2 Normative references ..1. 3 Terms and definitions 4 Symbols and abbreviated terms ..4 5 General requirements .5 5.1 General conditions. .5 5.2 .5 Tests.. 5.3 Test procedure. .6 5.4 Preparation of the DUT for testing. 1 5.4.1 Preparation of battery pack .7 5.4.2 Preparation of battery system .7 6 General test methods. ..8 6.1 Pre-conditioning cycles ..8 6.1.1 Purpose ..8 6.1.2 Test procedure ..8 6.2 Standard cycle (SC) ..8 6.2.1 Purpose ..8 6.2.2 Test procedure .8 7 Performance test. .9 7.1 Energy and capacity at RT .9 7.1.1 Purpose .9 7.1.2 Test procedure ..9 7.1.3 Requirement. .10 7.2 Energy and capacity at different temperature and discharge rates ..10 7.2.1 Purpose ..10 7.2.2 Test procedure .10 7.2.3 Requirements ..12 7.3 Powerand internal resistance. ..13 7.3.1 Purpose .13 7.3.2 Pulse power characterization profile .13 7.3.3 Test procedure .17 7.3.4 Requirements .18 7.4 No load SoC loss .19 7.4.1 Purpose. .19 7.4.2 Test procedure 19 7.4.3 Test sequence. 20 7.4.4 Requirement. 20 7.5 Soc loss at storage. 21 7.5.1 Purpose 21 7.5.2 Test procedure 21 7.5.3 Test sequence. 21 7.5.4 Requirement 22 7.6 Cycle life 22 7.6.1 Purpose 22 7.6.2 Test procedure .22 7.6.3 Requirements .22 8 Safety and reliability test. .23 8.1 Vibration. .23 8.1.1 Purpose 23 iii ISee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 d without license from IHS