ISO INTERNATIONAL STANDARD 18388 First edition 2016-02-15 Technical product documentation (TPD) Relief grooves Types and dimensioning Documentation technique de produits (DPT) - Rainures en relief - Types et dimensionnement Reference number ISO 18388:2016(E) ISO International Organization for Standardization =ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02016 No reproduction or networking permitted without license from IHS IS0 18388:2016(E) COPYRIGHT PROTECTED DOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either Iso at the address below or Iso's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinir DrganizationforStandardization Licensee-ZHEJIANG INST.OF STANDARDIZAROISQ 0d6 - All rights reserved Not for Resale, 2016/4/26 02:11:15 No reproduction or networking permited without license from IHS IS0 18388:2016(E) Contents Page Foreword ..iv 1 Scope 1 2 Normative references 3 Terms and definitions 4 Dimensions 4.1 Relief groove type E .1 4.2 Relief groove type F 4.3 Relief groove type G .2 4.4 Relief groove type H. 3 5 Dimensions of the relief grooves 5.1 Relief grooves. 4 5.2 Countersink at the counterpart 6 Designation 7 Presentation on the drawing 7.1 General .6 7.2 Conventional representation 7.3 Simplified representation. 7 Bibliography .8 Licensee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 ii vided by IHS under se with ISt Not for Resale, 2016/4/26 02:11:15 without license from IHS