ISO INTERNATIONAL STANDARD 19066-1 First edition 2014-10-01 Plastics Methyl methacrylate acrylonitrile-butadiene-styrene (MABs) moulding and extrusion materials - Part 1: Designation system and basis for specifications Plastiques - Matériaux plastique (meéthacrylate de méthyle)- acrylonitrile-butadiene-styrene (MABS) pour moulage et extrusion - Partie 1: Systeme de deésignation et base de spécifications Reference number IS0 19066-1:2014(E) ISO Copyright International Organization for Standardization @ IS0 2014 Not for Resale IS0 19066-1:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS0 19066-1:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope.. 2 Normative references 3 Designation system 2 3.1 General .2 3.2 Data block 1 3.3 Data block 2 3 3.4 Data block 3 3.5 Data block 4 4 3.6 Data block5 .6 4 Example of a designation 6 ii ded by IHS under lic ense with ISt ted without license from IHS Not for Resale