ISO INTERNATIONAL STANDARD 19632 First edition 2015-07-15 Aerospace series Fitting end, 24° internal cone, external thread, flareless type extra fine thread pitch inch series Design standard Série aérospatiale - Raccord, cone interne a 24 filetage externe, de type sans épanoui, filetage a pas extra fin, série inch - Norme deconception (na 1211 Reference number IS0 19632:2015(E) SO @IS02015 IS0 19632:2015(E) 1211A mnR 1211 121 COPYRIGHTPROTECTEDDOCUMENT 5 @ IS0 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either Iso at the address below or ISo's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel.+41227490111 Fax +41 22 749 09 47 copyright@iso.org www.iso.org ii @ IS0 2015 - All rights reserved IS0 19632:2015(E) Contents Page Foreword .iv Introduction. ..V 1 Scope. 1 2 Normativereferences 1 3 Required characteristics - Configuration, dimensions and tolerances 4 Designation @ IS0 2015 - All rights reserved iii