ISO INTERNATIONAL STANDARD 6361-2 Fourth edition 2014-09-15 Wrought aluminium and aluminium alloys Sheets, strips and plates Part 2: Mechanical properties Aluminium et alliages d'aluminium corroyés - Toles, bandes et toles épaisses- Partie 2: Propriétés mécaniques Reference number IS0 6361-2:2014(E) ISO @IS02014 IS0 6361-2:2014(E) COPYRIGHT PROTECTED DOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland i @ IS0 2014 - All rights reserved IS0 6361-2:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Tensile testing 5 Bend testing ..1 6 Mechanical properties .2 6.1 Tensile test .2 6.2 Bend test. ..2 Annex A (normative) Rules for rounding results obtained by inspection and testing ..50 Bibliography ..51 @ IS0 2014 - All rights reserved iii