ISO INTERNATIONAL STANDARD 6460-2 Second edition 2014-12-01 Motorcycles - Measurement method for gaseous exhaust emissions and fuel consumption - Part 2: Test cycles and specific test conditions Motocycles - Méthode de mesure des émissions de gaz d'échappement et de la consommation de carburant- Partie 2: Conditions d'essai spécifiques et cycles d'essai Reference number ISO 6460-2:2014(E) SO International Organization for Standardization @ IS0 2014 ed without license from IHS IS0 6460-2:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland Prganizationfor Standardization Not for Resale, 2015/3/20 06:39:00 networking permitted without license from IHS IS0 6460-2:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Test cycle 1 ..1 3.1 General .1 3.2 Type 1 test. 3.3 Type 2 test. .8 4 Test cycle 2. .9 4.1 General. .9 4.2 Test room conditions .9 4.3 Motorcycle classification ..9 4.4 Type 1 tests .11 4.5 Type 2 tests. .17 4.6 Test procedures 18 4.7 Analysis of results. 21 4.8 Driving cycles for type 1 tests .23 5 Presentation of results .61 Annex A (normative) Presentation of results for gaseous exhaust emissions. .62 Annex B (normative) Presentation of results offuel consumption .65 Annex C (informative) Test cycles ..69 Bibliography .71 iii ee=Zhejiang Institute of Standardization 5956617 vided by IHS under I ithout license from IHS