ISO INTERNATIONAL STANDARD 6932 Fourth edition 2014-03-15 Cold-reduced carbon steel strip with a maximum carbon content of 0,25 % Feuillards en acier au carbone laminés a froid avec une teneur maximale en carbone égale a 0,25 % Reference number IS0 6932:2014(E) ISO @IS02014 IS0 6932:2014(E) Contents Page Foreword .iv 1 Scope .1 2 Normative references .1 3 Terms and definitions .1 4 Dimensions .2 5 Chemical composition .2 5.1 General 2 5.2 Heat analysis 2 5.3 Product analysis 2 6 Conditions of manufacture .4 6.1 Physical properties. .4 6.2 Steelmaking 4 6.3 Weldability .7 6.4 Application .7 6.5 Mechanical properties .7 6.6 Oiling. 7 6.7 Edges. .7 6.8 Surface finish .8 7 Dimensional and shape tolerances .8 8 Sampling Hardness or tensile test .11 9 Mechanical property tests ..11 9.1 Hardness test .11 9.2 Tensile test. 11 10 Retests .12 10.1 Machining and flaws. 12 10.2 Additional tests. 12 11 Resubmission .12 12 Workmanship .12 13 Inspection and acceptance ..12 14 Coil size. .12 15 Marking .12 16 Information to be supplied by the purchaser ..13 Bibliography .14 IS02014-Allrightsreserved iii IS0 6932:2014(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of IsO documents should be noted. This document was drafted in accordance with the editorial rules of the ISo/IEC Directives, Part 2 (see www.iso.org/directives). Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISo list of patent declarations received (see www.iso.org/patents). Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement. For an explanation on the meaning of IsO specific terms and expressions related to conformity assessment, as well as information about IsO's adherence to the WTO principles in the Technical Barriers to Trade (TBT) see the following URL: Foreword - Supplementary informatior The committee responsible for this document is ISO/TC 17, Steel, Subcommittee SC 12, Continuous mill flat rolled products. This fourth edition cancels and replaces the third edition (Is0 6932:2008), which has been technically revised. @ IS0 2014 - All rights reserved