ISO INTERNATIONAL STANDARD 8029 Third edition 2014-08-15 Plastics hose General-purpose collapsible water hose, textile- reinforced Specification Tuyaux plastiques - Tuyaux d'eau écrasables d'usage général renforcés textiles-Spécifications Reference number IS0 8029:2014(E) LSO IS02014 IHS under ted without license from IHS Not for Resale IS0 8029:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 8029:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms and definitions 4 Classification .2 5 Couplings and end fittings .2 6 Materials and construction ..2 7 Dimensions and tolerances .2 7.1 Inside diameter and tolerance .2 7.2 Tolerance on length .3 8 Physical properties .4 8.1 Plastic compounds ..4 8.2 Performance requirements for finished hose ..4 9 Frequency of testing ..9 10 Test certificate/report ..9 11 Marking .9 12 Recommendations for packaging and storage ..10 Annex A (normative) Abrasion test ..11 Annex B (normative) Type and routine testing ..13 Annex C (informative) Production tests .14 Annex D (informative) Couplings and end fittings ..15 Bibliography. .16 iii ut license from IHS Not for Resale