ISO INTERNATIONAL STANDARD 8033 Fourthedition 2016-12-15 Rubber and plastics hoses Determination of adhesion between components Tuyaux en caoutchouc eten plastique-Determination de I'adhérenceentreélements Reference number IS0 8033:2016(E) ISO Intemational Organization for Standardization IS02016 itted without license from IHS IS0 8033:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS02016,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 copyright@iso.org www.iso.org Intemationaibr PrganizationforStandardization etworking permitted without license from IHS IS0 8033:2016(E) Contents Page Foreword ..iv 1 Scope 2 Normative references 3 Terms and definitions 4 Principle ..2 5 Apparatus. 2 5.1 General .2 5.2 Testmachine .2 5.3 Grips.. 2 5.4 Mandrel .2 6 Testpieces .2 6.1 Types of test piece. 22 6.1.1 General. 6.1.2 Type 1 2 6.1.3 Type 2 2 6.1.4 Type 3 3 6.1.5 Type 4. 3 6.1.6 Type 5 3 6.1.7 Type 6. 3 6.1.8 Type 7. 3 6.1.9 Type 8. 3 6.2 Test piece selection .3 6.3 Testpiecepreparation 4 6.3.1 General. .4 6.3.2 Type 1 4 6.3.3 Type 2 .4 6.3.4 Type 3 .4 6.3.5 Type 4. 5 6.3.6 Type 5 5 6.3.7 Type 6. 5 6.3.8 Type 7. .5 6.3.9 Type 8. .5 6.4 Conditioningoftestpieces .6 6.5 Time interval between vulcanization and testing .6 7 Procedure .6 7.1 Preparation ..6 7.2 Insertionoftestpieces .6 7.3 Test speed. ..6 7.4 Measurement ..6 8 Expression of results ..6 9 Test report .7 Bibliography .13 iii ed without license from IHS