ISO INTERNATIONAL STANDARD 834-10 First edition 2014-03-01 Fire resistance tests Elements of building construction - Part 10: Specific requirements to determine the contribution of applied fire protection materials to structural steel elements Essais de résistance au feu - Eléments de construction - Partie 10: Exigences spécifiques pour determiner la contribution des matériaux de protection appliqués aux élements des structures en acier Reference number IS0 834-10:2014(E) LSO @ IS0 2014 I without license from IHS Not for Resale IS0 834-10:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 834-10:2014(E) Contents Page Foreword ..V Introduction. ...vi 1 Scope 2 Normative references 3 Terms and definitions 4 Symbols and abbreviated terms ..4 5 Test equipment. .5 5.1 General. .5 5.2 Furnace. .5 5.3 Loading equipment .5 6 Test conditions .5 6.1 General 6.2 Support and loading conditions 7 Test specimens. .11 7.1 General 11 7.2 Specimen design and preparation. .12 7.3 Composition of test component materials ..16 7.4 Selection of test specimens. .19 8 Installation of the test specimens. .20 8.1 Loadedbeams. 20 8.2 Unloaded beams .21 8.3 Loaded columns. 21 8.4 Unloaded columns 21 8.5 Test specimen installation patterns 21 8.6 Furnace load 22 9 Conditioning of the test specimens. .22 10 Application of instrumentation .23 10.1 General 23 10.2 Instrumentation for measurement of furnace temperature. 23 10.3 Instrumentation for measurement of steel temperatures .25 10.4 Instrumentation for measurement of furnace pressure 29 10.5 Instrumentation for measurement of deformation. 30 10.6 Instrumentation for measurement of load ..30 11 Test procedure. .30 11.1 General. 30 11.2 Furnace temperature and pressure .30 11.3 Application and control of load .30 11.4 Measurementsandobservations .31 12 Testresults .31 12.1Acceptability of test results. .31 13 Presentation of test results ..32 14 Test report. ..33 14.1 General .33 Annex A (normative) Measurement of properties of passive fire protection materials. ...35 Annex B (normative) Measurement of properties of reactive protection materials ...38 Annex C (normative) Selection of test specimens - passive fire protection ..40 iii ded by IHS under lic ense with ISC ted withoutlicensefrom IHS Not for Resale