ISO INTERNATIONAL STANDARD 9366 Second edition 2001-05-01 Agglomerated cork floor tiles - Determination of dimensions and deviation from squareness and from straightness of edges Dalles d'aggloméré de liege pour revetements de sol- Détermination des dimensions et des écarts de I'équerrage et de la rectitude des bords Reference number ISO 9366:2001(E) ISO @ ISO 2001 Not for Resale ISO 9366:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is atrademarkofAdobeSystems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Casepostale56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland yationgazaiSandardizatio @ISO2001-All rightsreserved itted without license from IHS Not for Resale ISO 9366:2001(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through isO technical liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote patent rights. IsO shall not be held responsible for identifying any or all such patent rights. InternationalStandardISO9366waspreparedbyTechnicalCommitteeISO/TC87,Cork. This second edition cancels and replaces the first edition (IsO 9366:1990), which has been technically revised. ii