ISO INTERNATIONAL STANDARD 9454-1 Second edition 2016-02-01 Soft soldering fluxes Classification and requirements Part 1: Classification, labelling and packaging Flux de brasage tendre - Classification et exigences - Partie 1: Classification, marquage et emballage Reference number IS0 9454-1:2016(E) ISO International Organization for Standardization @ IS0 2016 ed without license from IHS IS0 9454-1:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS02016,PublishedinSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Intenationaibr PrganizationforStandardization icensee-ZHEJIANG INST OF STANDARDIZoISQ s.6 - All rights reserved Not for Resale, 2016/4/22 08:01:19 etworking permitted without license from IHS IS0 9454-1:2016(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Classification of fluxes 3 Labelling and packaging. Annex A (informative) Grades of fluxes Annex B (informative) Testing of fluxes .6 Bibliography 9 Inteatinal oganzation @st(S.201.6 - All rights reserved iii ee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under I se with ISt ed without license from IHS Not for Resale, 2016/4/22 08:01:19