ISO INTERNATIONAL STANDARD 9738 First edition 2000-12-15 Aerospace Turnbarrels, for aircraft control wire rope Dimensions and loads Aeronautique et espace Douilles de tendeurs de cables de commande d'aeronefs - Dimensions et charges [so Reference number ISO 9738:2000(E) E"eqr[tkijvgf'd{"WPG."E1"1gpqxc."8l"4 :226"Ocftkf."Urckp"cn'tkijv gugtxgf+"Uwp*Hgd'3 :*24<5 :<5 :WVE*4246 ISO9738:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is atrademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the ISO 2000 or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56· CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii E*eqr[tkijvgf"d["WPG.'E1"1gpqxc."8I"4:226°Ocftkf.'Urckp"cm'tkijv'tgugtxgf+*'Uwp"Hgd’3:*24<5 :<5 :WVE"4246 @ISO ISO 9738:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote Subcommittee SC 12, Mechanical system parts. AnnexAformsanormativepartofthisInternationalStandard ili E'eqr[tkijvgf"