INTERNATIONAL ISO/IEC STANDARD 24769-62 First edition 2015-10-01 Information Technology Real Time Locating System (RTLS) Device Conformance Test Methods Part 62: High rate pulse repetition frequency Ultra Wide Band (UWB) air interface Technologies de I'information - Methodes d'essai de conformite du dispositif des systemes de localisation en temps réel (RTLS) Partie 62: Meéthodologie de test de interface aérienne ultra large bande (UWB) a impulsions haute fréquence de répeétition Reference number IS0/IEC 24769-62:2015(E) ISO LIEC @IS0/IEC 2015 IS0/IEC 24769-62:2015(E) COPYRIGHT PROTECTED DOCUMENT IS0/IEC 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form writtenpermission.Permission canberequestedfromeitherIsOattheaddressbelow orIso'smemberbodyinthecountryof the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org ii @ IS0/IEC 2015 - All rights reserved IS0/IEC 24769-62:2015(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms, definitions and abbreviated terms ..1 3.1 Terms and definitions .1 3.2 Abbreviated terms.. Conformance tests for IS0/IEC 24730-62. .2 4 4.1 General. 2 4.2 Default conditions applicable to the test methods .2 4.2.1 Preface 2 4.2.2 Test environment. .2 4.2.3 Default tolerance. 2 4.2.4 Noise floor at test location. .2 4.2.5 Total measurement uncertainty 3 4.3 UWB RF transmission tests. 3 4.3.1 General 3 4.3.2 Test Objective 3 4.3.3 Test procedure .3 4.3.4 Test measurements and requirements 4 4.3.5 Test report. 4.4 Receiver UWB RF tests 4 4.4.1 Preface 4.4.2 General 4 4.4.3 Test objective .5 4.4.4 Test procedure 5 4.4.5 Test measurements and requirements 5 4.4.6 Test report. .5 Annex A (normative) RF test measurement site. 6 @ IS0/IEC 2015 - All rights reserved iii