ISO INTERNATIONAL STANDARD 12215-4 First edition 2002-05-01 Small craft Hull construction and scantlings - Part 4: Workshop and manufacturing Petits navires Construction de coques et échantillons - Partie 4: Ateliers de construction et fabrication Reference number ISO 12215-4:2002(E) ISO @ ISO 2002 IHSunder Not for Resale ISO 12215-4:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event ?ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @IsO2002-All rights reserved itted without license from IHS Not for Resale ISO 12215-4:2002(E) Contents Page Foreword. .iv 1 Scope 2 Normative references. 3 Fibre-reinforced plastics (FRP) boat production . 4 Metal craft production, steel and aluminium . 6 5 Aluminiumcraftproduction,specificrequirements.. .8 6 Wooden boat production < Boat production using other materials .. ..10 8 Qualification of personnel... 6 Final inspection ... 10 Conformity assurance ili IHS under from IHS Not for Resale