ISO INTERNATIONAL STANDARD 15750-2 First edition 2002-04-15 Packaging Steel drums Part 2: Non-removable head (tight head) drums with a minimum total capacity of 212 I, 216,5 I and 230 I Emballages - Futs en acier - Partie 2: Futs a ouverture partielle d'une capacite totale minimale de 212 l, 216,5 /et 230 / Reference number ISO 15750-2:2002(E) @ ISO 2002 IHS unde Not for Resale ISO 15750-2:2002(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ ISO 2002 - All rights reserved itted without licensefrom IHS Not for Resale ISO 15750-2:2002(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission(lEC)onallmattersofelectrotechnicalstandardization. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. ISO 15750-2 was prepared by Technical Committee ISO/TC 122, Packaging. IsO 15750 consists of the following parts, under the general title Packaging — Steel drums: Part 1: Removable head (open head) drums with a minimum total capacity of 208 I, 210 / and 216,5 / Part 2: Non-removable head (tight head) drums with a minimum total capacity of 212 I, 216,5 / and 230 / Part 3: Inserted flange-type closure systems Annexes A and B form a normative part of this part of iSO 15750. nafionai Onganizatinfor StandardizalinServed ili