ISO INTERNATIONAL STANDARD 16037 First edition 2002-05-15 Rubber condoms for clinical trials - Measurement of physical properties Préservatifs masculins en caoutchouc destinés aux essais cliniques - Mesurage des propriétés physiques Referencenumber ISO 16037:2002(E) @ISO2002 No reproduction or networking pemited without license from IHS Not for Resale ISO 16037:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's memberbody in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland yatgzaiSandardizatn @ ISO 2002 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 16037:2002(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO liaison with IsO, also take part in the work. sO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. Copyriat intenatinal iranizain tor Standardization served ii Not for Resale