ISO INTERNATIONAL STANDARD 16162 Fourth edition 2012-08-15 Cold-rolled steel sheet products Dimensional and shape tolerances Toles en acier laminées a froid Tolérances sur dimensions et forme Reference number ISO 16162:2012(E) ISO @ISO2012 ed by IHS under lic No reproduction or networking permitted without license from IHS Not for Resale ISO 16162:2012(E) COPYRiGHTPROTECTEDDOCUMENT ISO 2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2012 - All rights reserved Not for Resale ISO 16162:2012(E) Foreword SO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 16162 was prepared by Technical Committee ISO/TC 17, Steel, Subcommittee SC 12, Continuous mill flat rolledproducts. This fourth edition cancels and replaces the third edition (isO 16162:2010), which has been technically revised. ii Not for Resale