ISO INTERNATIONAL STANDARD 16431 First edition 2012-01-15 Hydraulic fluid power s System clean- up procedures and verification of cleanliness of assembled systems Transmissions hydrauliquesSystemes assemblés-Procedures de dépollution d'un systeme et verification de sa propreté Reference number ISO 16431:2012(E) LSO @ISO 2012 IHS under itted without license from IHS Not for Resale ISO 16431:2012(E) COPYRIGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISo copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2012 - All rights reserved No reproduction networking permitted without license from IHS Not for Resale ISO 16431:2012(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 16431 was prepared by Technical Committee ISO/TC 131, Fluid power systems, Subcommittee SC 6 Contaminationcontrol. This first edition of ISO 16431 cancels and replaces ISO/TS 16431:2002, which has been technically revised. ii Not for Resale