ISO INTERNATIONAL STANDARD 25178-701 First edition 2010-07-01 Geometrical product specifications (GPS) Surface texture: Areal - Part 701: Calibration and measurement standards for contact (stylus) instruments Specification geometrique des produits (GPS)Etat de surface: Surfacique Partie 701:Etalonnage et étalons de mesure pour les instruments a contact(apalpeur) Accessed by UNSW - LIBRARY on 15 Jun 2016 (Document currency not guaranteed when printed) Reference number ISO 25178-701:2010(E) @ISO2010 ISO 25178-701:2010(E) PDFdisclaimer shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT ISO 2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body inthe country of the requester. ISO copyright office Casepostale56.CH-1211Geneva20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISO 2010 -All rights reserved ISO 25178-701:2010(E) Contents Page Foreword .iv Introduction 1 Scope 2 Normative references. 3 Terms and definitions. 4 General... 5 Measurementstandards.. 6 Calibration andperiodicalverification procedures AnnexA (informative)Assessment of the residual errors. .18 Annex B (informative) Example of an instrument data sheet. AnnexC (informative)RelationwiththeGPS matrix Bibliography.... @ ISO 2010 - All rights reserved ili